MBM Corporation BC 12 - Manual (Page 31)

29
5.13.2 When “E006” is displayed
∗ “E006” indicates that a sheet of paper was drawn into the machine but it was stopped because the
sensor that detects the edge of paper (S2 sensor) cannot detect the edge properly.
∗ “E006” also occurs when a piece of paper such as a margin that was cut during cutting operation does
not fall into the trash box but remains near the sensor (S2 sensor).
∗ Turn off the power switch, open the top panel and paper feed unit, and remove the remaining sheet or
scrap of paper.
∗ Securely close the top panel and paper feed unit and turn on the power switch.
(When closing the paper feed unit, securely tighten the thumbscrew of the paper feed unit fixing
bracket.)
∗ If “E006” is still displayed, press the Ready/Clear Key.
5.13.3 When “E007” is displayed
∗ “E007” occurs when paper does not reach the S3 sensor within the time frame set by the operation
program of this machine. In other words, the paper is stopped (or stuck) somewhere between the S2
sensor and S3 sensor.
∗ Turn off the power switch, open the top panel and pull out the pressure roller unit upward.
∗ Remove the sheet or scrap of paper remaining in the machine.
∗ Install the pressure roller unit in the proper position, close the top panel, then turn on the power switch.
∗ If “E007” is still displayed, press the Ready/Clear Key.
∗ If this error cannot be released by this procedure, other paper may be remaining under the paper feed
unit. Check this part, too. (See 5.13.2.)
5.13.4 When “E008” is displayed
∗ “E008” occurs when the paper has not passed through the S3 sensor within the time frame set by the
operation program of the machine. In other words, the paper is stopped (or stuck) somewhere at or
after the S3 sensor and before ejection.
∗ Turn off the power switch, open the top panel and pull out the pressure roller unit upward.
∗ Remove the sheet or scrap of paper remaining in the machine.
∗ If paper is remaining not only in the pressure roller unit but also in the slitter cartridge, open the slitter
cover and remove the paper from the ejection outlet side of the slitter cartridge.
∗ When removing the jammed paper from the ejection outlet side of the slitter cartridge, pick it up and
pull it out using tweezers, etc.
(Never put your fingers inside the ejection outlet, as the slitter blade inside could cause an injury.)