MBM Corporation BC 12 - Manual (Page 24)

22
5.6 Selecting the counter mode
∗ If the adding mode is selected using the Mode Key, the adding LED lamp lights up and the cumulative
number of cut products is displayed on the display panel.
∗ If the machine is operated in adding mode, the machine continues operating until the Stop Key is
pressed, or until there is no more paper in the paper feed tray.
∗ If the preset mode is selected, the preset LED lamp lights up, and by pressing the ▲ or ▼ Key, the
preset number (number of products) can be increased or decreased. The set number of products will
then be cut.
∗ If the machine is operated in preset mode, when the preset number displayed on the display panel
becomes “0000”, the machine stops and stands by, and the preset number will be displayed again.
∗ If the machine is operating based on the preset number, when it runs out of paper in the paper feed tray,
the machine stops and the remaining number of products to be cut will be displayed. If additional
paper is loaded on the tray and the Start Key is pressed, the machine will restart and cut the remaining
number of sheets.
∗ The minimum number of sheets that can be preset varies depending on the selected cutting mode and
the slitter unit. Thus, the number of products imposed on letter-size and legal-size paper becomes the
minimum unit, and multiples of this unit can be preset.
5.7 Adjusting the top margin (if necessary)
∗ If there is a misalignment in the first cutting position, such as shear in printing, in the direction of the
long side of letter-size and legal-size paper, this can be used for adjustment.
(Adjustable range: ±1mm)
∗ First, select the cutting mode under which the top margin width is adjusted. (Keep pressing the Select
Key.)
∗ If the Adjust Top Margin Key is pressed, the pilot LED lamp on the right of the display panel is
switched, the Adjust Top Margin LED lamp lights up, and the present set value of the top margin will
be displayed.
∗ By pressing the ▲ or ▼ key, adjustments can be made in increments of 0.1mm
(Adjustable range: ±1mm).
∗ When the adjustment is finished and the Adjust Top Margin Key is pressed, the set value is stored and
the display panel shows the number of products again.
∗ The initial values of the top margin width are set as follows for each cutting mode.
Initially set values of top margin
Cutting mode 1: 0.5” Cutting mode 6: 0. 0”
Cutting mode 2: 0.25” Cutting mode 7: 0. 0”
Cutting mode 3: 0.5” Cutting mode 8: 0.0”
Cutting mode 4: 0.0” Cutting mode 9: 0.25”
Cutting mode 5: 0.5” Cutting mode 10: 0.33”
∗ In cutting mode 4, 6, 7 or 8, no top margin is left. Therefore, if the top margin is adjusted, the cutting
dimensions of the first sheet are adjusted.