MBM Corporation FMM3 - Manual (Page 6)

Setting Up Your Machine
Leveling Feet
Page 05
Step #1 If needed, adjust the feet on the underside of the base to
level the machine. Start by loosening the Lock Nuts
from inside the stand. Level by rotating the feet up or
down to the desired height as shown. When they are
adjusted as desired, tighten down the Lock Nuts again.
Paper Side Stops
Step #2 Attach the Paper Side Stops (FM4-4006) using two Side
Stop Screws (FM4-4007) each. Position the Paper Side
Stop as desired and tighten down with light pressure.
Master Chip Chute
Step #3 Attach the Master Chip Chute (FMM6-651A) by inserting
the two hooks located on the wide end of the Master
Chip Chute into the rectangular opening in the upright as
shown. The hooks are on the bottom of the Master Chip
Chute and hook over the bottom of the opening.
Leveling Feet
Base of the Machine
Nut
Table
Paper Side Stop
Side Stop Screws
Chip Chutes
Master Chip Chute