MBM Corporation FMM3 - Manual (Page 16)

Maintenance
Page 15
Every 12 Months (or as needed depending on use)
Visually check the Flex Drive Pivot Assembly for unusual wear.
Check the Pivot Assembly bolts and tighten if necessary.
Note: Be sure the wiring is clear of all moving components and is
properly attached when replacing the Shroud.
Press down on the Foot Treadle to Raise the Table. Manually
holding the Table in place, slowly let up on the Foot Treadle so
that the Push Rods in the rear of the machine fall out of the Pin
Housings.
Lubricate the tips of the Push Rods and while holding up the
Table return the Push Rods into the Pin Housings. Release the
Table so that the Push Rods are locked in place.
Push down on the Foot Treadle to check for freedom of Travel.
CAUTION: KEEP FINGERS FROM BETWEEN LIFT COMPONENTS.
OBSERVE ALL SAFETY PRECAUTIONS DURING THE PREVENTATIVE
MAINTENANCE OF THIS MACHINE.
Flex Drive
Pivot Assembly Flex Drive
Pivot Assembly
Lubricate
Push Rods
Rear View