Maintenance, Page 13 – MBM Corporation FMM3 User Manual

Page 14

Maintenance

Page 13

Note:

Some play between the Idler Pulley Bearings and the Idler

Pins comply with original specifications and is not a

problem.

Every 12 Months (or as needed depending on use)

Make sure to unplug the machine from the power supply before

conducting any maintenance.

Remove the Table by loosening the left end Stop Collar on the

Stop Bar Assembly and rotating the Table Traverse Stop down

to clear the Pedestal. Pull the Table to the right until the Table

clears the slide beneath the Table. Inspect the slide for build-up

and lubricate with light machine oil. Using the Foot Treadle

raise the Slide and Lubricate the bars underneath the Slide as

shown. Replace the Table in the same manner as it was

removed and check the Table traverse for free travel.

Lubricate the Stop Pin with light machine oil, work the pin up

and down and rotate it a few times for proper lubrication.

Lubricate the pivot points, shown in the diagram, in the lower

back portion of the machine with light machine oil. Lubricate the

Treadle Pivot Assembly at the front of the machine in the same

manner.

Making sure the machine is unplugged and after disconnect-

ing the electrical wiring to the Switch on the shroud, remove the

shroud by lifting straight up to clear the drive mechanism making

sure the Traverse Locks are disengaged. Lubricate the two (2)

Idler Pulleys with a good grade of grease. A grease gun is

required (not included). Rotate the belts by hand to check the

Idler Pulleys for wear

Lubricate

Grease Points

Belt

Pedestal

Table Assembly

Slide