Dish Network DuoDVR 625 - Manual (Page 107)

Chapter 3
Page 102
Using the System
Turning Caller ID On and Off
1. Press MENU on the Remote Control.
2. Select System Setup .
3. Select Installation .
4. Select Caller ID .
5. Select Enable Caller ID or select Disable Caller ID .
6. Select Done .
Resetting Receiver to Factory Default Settings
Note : Resetting the receiver to factory default settings discards all Favorite
Lists except the All Chan and All Sub lists.
Note : If you have set any locks on the receiver, and the receiver is locked, these
locks will be kept. If the receiver is unlocked, any such locks will be lost. You
cannot reset the receiver to default settings to discard a password you have
forgotten. Only a Customer Service Representative can reset the receiver to
bypass a receiver lock.