Maytag MDG9800AWQ Installation - Manual (Page 2)

Page 1
• Teflon tape or pipe
joint compound (gas only)
• Cutting knife
• Pipe wrench
(gas only)
• Nut drivers
• Level
• Screw driver
(standard)
• Duct tape
• Crescent wrench
Proper installation is the responsibility of the owner.
HOWEVER, SERVICE CALLS PERFORMED AS A RESULT OF POOR SET-UP, ADJUSTMENT AND CON-
NECTION ARE THE RESPONSIBILITY OF THE INSTALLER.
Make sure you have everything necessary for proper installation.
1. GROUNDED ELECTRICAL OUTLET is required. See Electric Requirements.
2. POWER CORD for electric dryers (except Canada).
3. GAS LINES (if a gas dryer) must meet National and Local Codes.
4 . E X H AUST SYSTEM – must be rigid metal or flex i ble stiff walled metal exhaust ducting. See Exhaust R e q u i r e m e n t s.
Read this before you start…
ITEMS PROVIDED
Electric Dryer
Only
Gas Dryer
Only
Tools needed for installation
3/4”
(1.9 cm)
1 1/2”
(3.81 cm)
6 13/16”
(17.3 cm)
3 5/8”
(9.2 cm)
16”
(40.6 cm)
3/8” minimum
(1 cm)
Base
Exhaust
Base
Exhaust
Gas Pipe
22 1/4”
(56.5 cm)
27 1/2”
(69.9 cm)
2 7/16”
(6.2 cm)
3 7/16”
(8.7 cm)
3 1/4”
(8.3 cm)
27”
(68.9 cm)
43 1/4”
(109.9 cm)
minimum
36 1/4”
(92.1 cm)
minimum
IMPORTANT TO INSTALLER
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY BEFORE STA RTING TO INSTALL T H E
D RY E R . THESE INSTRUCTIONS SHOULD BE RETAINED FOR FUTURE REFERENCE.
REMOVE THE DOOR FROM ALL DISCARDED APPLIANCES SUCH AS DRYERS TO AVOID THE
DANGER OF A CHILD SUFFOCATING.
13 1/2”
(34.3 cm)