Mathey Dearman CGM Cold Cutting System - Manual (Page 21)

21
9.2 – Manufacturers of Hydraulic, Trade Mark and Viscosity Index
DIAGRAM A B C
Viscosity 32 46 68
Specification
DIN 51524
H – LP 32 H – LP 46 H – LP 68
Viscosity to
50°C / 122°F
16 - 20 24 - 28 31 - 39
AGIP
IP
BP
CASTROL
ESSO
MOBIL
SHELL
CHEVRON OSO 32
HYDRUS 32
ENERGOL – HLP 32
HYSPIN – AWS 32
NUTO H 32
DTE 24
TELLUS 32
EP HYDRAULIC OIL 32 OSO 46
HYDRUS 46
ENERGOL – HLP 46
HYSPIN – AWS 46
NUTO H 46
DTE 25
TELLUS 46
EP HYDRAULIC OIL 46 OSO 68
HYDRUS 32
ENERGOL – HLP 68
HYSPIN – AWS 68
NUTO H 68
DTE 26
TELLUS 68
EP HYDRAULIC OIL 68
9.3 - Viscosity to Temperature Ratio
Viscosity
Celsius Temperature
The principle cause of most machine break downs and failure of hydraulic components is blockage, seizing up or
breaking of hydraulic components caused by the wear and aging of the hydraulic fluid. The CGM-1 should not be
connected to Hydraulic Power Supply if the hydraulic fluid in the Reservoir is brown (aged or dirty) or milky (contains
water). The Warranty will be VOIDED if it is determined the hydraulic fluid is found to be in this condition.