Marantz PM-11S3 - Manual (Page 19)

15
Getting started
Basic connections
Basic operation
Troubleshooting
Specifications
Index
Advanced operation
Explanation terms
ENGLISH
Advanced connections
F.C.B.S. connection
n How to set ID number for F.C.B.S.
When the unit is turned on, the display shows the ID number for three seconds.
For a master unit, ID number 1 needs to be assigned.
For a slave unit, set any of ID numbers 2 to 4.
X ON/OFF PHONES
VOLUME A
TONE
SPEAKERS
B SPEAKERS
PRE OUT
ATT.
MC
STANDBY
PHONO
IN P.DIRECT
DISPLAY
SELECTOR INPUT
INTEGRARED AMPLIFIER PM-11S3
INPUT SELECTOR
DISPLAY
X ON/OFF
1
While holding DISPLAY on the unit, press X ON/OFF .
2 Turn INPUT SELECTOR on the unit to select an ID number.
3 Turn the unit off.
4 Again turn the unit on.
• The setting is saved.
• The unit registered as a slave shows “SLAVE” on the display.
NOTE
• If using this unit by itself as a stereo amplifier, set the ID number to “0” (Default setting is
“0”).
• If the ID number is set to a number other than “0”, this unit cannot be used for standalone
operation.
1.PM-11S3U_ENG_0521.indd 15 2012/05/21 19:03:34