Marantz SR-14mkII - Manual (Page 18)

ENGLISH
11
Settings
ok, and cursor (^ / v / < / > )buttons
These buttons are used to navigate within on-screen menus.
(Refer to”ON-SCREEN MENU SYSTEM” on page 13-17)
Menu On and Off buttons
These buttons are used to turn on and off the on screen menu system.
CH. Sel button
Press this button to adjust the volume levels of the front, center,
surround, subwoofer
channels. Each press of the button changes the channel which can
be adjusted.
CH.Level (^ :up / v : down) buttons
Increases or decreases channel level volume
After pressing the CHSel button, use the ^ :up or
v : down buttons to
adjust the volume level of
each speaker channel.
OSD button
This button is used to turn on the On Screen Display for general
information.
Power
Power on / off buttons
These buttons are used to turn on or off SR-14mkII
Control (Tuner)
Band buttons
These buttons are used to switch between FM, AM, and LW mode of
the tuner.
LW button is not available in SR-14mkII.
Seek (< / > ) buttons
These buttons are used to change the frequency.
Preset (P+ / P- ) buttons
These buttons are used to change the preset station.
Mono button
This button is used to select the auto stereo mode or mono mode.
PTY button
Selects PTY function in RDS (Radio Data System) by this button.
Display button
Selects display mode function in RDS (Radio Data System) by this
button.
Keypad (Tuner)
ten keypad (0,1 - 9)
These buttons are used to change the preset station or input
frequency directly.
M (Memo) button
This button is used to enter the tuner’s preset memory numbers and
station names.
C (Clear) button
This button is used to cancel certain memory or programming
operations.
F/P buttons
This button is to select the display for frequency or preset channel .
PS (Preset Scan) button
This button is used to start a scan automatically through the
stations preset into the receiver’s memory.