Marantz NR1506 - Manual (Page 197)

Symptom Cause / Solution Page
Dolby PLg mode or DTS
Neo:6 mode cannot be
selected.
0
It cannot be selected when “Speaker Config.” - “Surround” is set for “None”. 167
0
Dolby PLg or DTS Neo:6 cannot be selected when using headphones. －
Audyssey MultEQ ® ,
Audyssey Dynamic EQ ®
and Audyssey Dynamic
Volume
® cannot be
selected.
0 These cannot be selected when you have not performed Audyssey ® Setup. 155
0
Switch to a sound mode other than “Direct” or “Pure Direct”. 105
0
These cannot be selected when using the headphones. －
“M-DAX” cannot be
selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of
multichannel signals such as Dolby Digital or DTS surround, “M-DAX” cannot be used.
137
0
Switch to a sound mode other than “Direct” or “Pure Direct”. 105
Contents Connections Playback Settings Tips Appendix
197
Front panel Display Rear panel Remote Index