Installation procedures – Lynx Studio LT-TB Thunderbolt User Manual
Page 9

9
5 Installation Procedures
Please insure that the Aurora has firmware 28 or above before proceeding. See
: Insuring compatible firmware
1. Remove the AC power cord and take the top cover off of the Aurora. There are seven
large screws plus one small alignment screw near the center-front of the top lid that holds
it on.
2. Before installing the LT-TB card, you must change a dipswitch setting on the Aurora that
corrects the current draw for an Aurora with an LT-TB. Please note: if you are replacing
a different LSLOT card with the LT-TB, it’s likely that the dipswitch setting is already in
the correct position.
Slide switch 4 (labeled W4 on PCB) of SW1 to the OFF position (towards back panel).
If you are updating an older Aurora that has jumper pins at JP6, instead of the W4
switches, please call Lynx Technical Support for instructions.
3. Remove the LSLOT Expansion Port cover above the AES I/O Ports by removing the two
mounting screws. Set these two screws aside, as they will be used to secure the LT-TB
after installation.