D-Link DIR-615 User Manual

Page 37

Section 3 - Configuration

This will allow you to open a single port. If you would like to open a range of ports, refer to page 38.

Enter a name for the rule or select an application

from the drop-down menu. Select an application

and click

<< to populate the fields.

Enter the IP address of the computer on your

local network that you want to allow the incoming

service to. If your computer is receiving an IP

address automatically from the router (DHCP),

you computer will be listed in the “Computer

Name” drop-down menu. Select your computer

and click

<<.

Enter the port that you want to open next to Private

Port and Public Port. The private and public ports

are usually the same. The public port is the port

seen from the Internet side, and the private port

is the port being used by the application on the

computer within your local network.

Select

TCP, UDP, or Both from the drop-down

menu.

Select

Allow All (most common) or a created

Inbound filter. You may create your own inbound filters in the

Advanced > Inbound Filter page.

The schedule of time when the Virtual Server Rule will be enabled. The schedule may be set to Always, which will allow the

particular service to always be enabled. You can create your own times in the

Tools > Schedules section.

Name:

IP Address:

Private Port/

Public Port:

Protocol Type:

Inbound Filter:

Schedule: