Lumens Technology VC-A20P - Manual (Page 30)

English - 29
7.2.5 Setting - advanced image encoding setting
1. Name of current connected camera
2. IP Ratio: Set IP Ratio, from 1 to 60
3. Force I Frame:
Check this item to insert IDR frame into specified series flow and apply its setting. User’s setting will be
reserved and displayed in GUI interface
4. Encode Preset:
Auto: Select between speed and quality depending on the encoding method used (e.g. HIGH_SPEED
mode for refresh rate of 60 frames per second and HIGH_QUALITY mode for high image quality)
HIGH_SPEED: Refresh rate of 60 frames per second is available
HIGH_QUALITY: Higher image quality can be obtained
SVC: SVC opened encoding mode is applicable to RTSP series flow of 8601, 8602, 8603 and 8604
ports, different refresh rate for different ports. See remark
5. Preset Save
SVC connection address: rtsp://VC IP Address:Port/h264
1. 60Frame : rtsp://VC IP Address:8557/h264, e.g.: rtsp://192.168.100.150: 8557/h264
2. 30Frame : rtsp://VC IP Address:8601/h264, e.g.: rtsp://192.168.100.150: 8601/h264
3. 15Frame : rtsp://VC IP Address:8602/h264, e.g.: rtsp://192.168.100.150: 8602/h264
4. 7Frame : rtsp://VC IP Address:8603/h264, e.g.: rtsp://192.168.100.150: 8603/h264
5. 3Frame : rtsp://VC IP Address:8604/h264, e.g.: rtsp://192.168.100.150: 8604/h264
7.2.6 Setting - camera
1. Name of current connected camera
2. Adjust camera brightness / contrast / saturation / sharpness, etc.
3. Preset Save
1
2
5
3
4
1
2
3