Lumens Technology VC-A20P - Manual (Page 16)

English - 15
4.3.2 Controlling VCs with the computer
4.3.2.1 Connecting to one computer for connection between VCs (RS-232 in/out)
With RS-232 in/out, at most 7 VCs can be connected.
4.3.2.2 Connecting to one computer for connection between VCs (RS-422)
Please refer to 8.2 RS-422 connection for the RS-422 connection instructions.
With RS-422, at most 7 VCs can be connected.
4.3.3 Use of VC-A20P with Internet Connection
4.3.3.1 Setup before use
 Connect DVI output to the screen.
 Press [MENU] on the Remote Control to display the OSD menu.
 Shift down to [Ethernet] to modify and confirm the IP address.
DHCP: Enable/disable the dynamic host configuration protocol
IP Address: Confirm or modify the IP address of VC-A20P
Subnet mask: 255.255.255.0
Gateway: Preset 192.168.100.1
[Remark] Please modify the above settings based on the LAN setting of the operating environment. To use
DHCP, please connect the VC-A20P to LAN and then confirm IP address.
 After completing settings, press [MENU] to exit the OSD menu.
 After completing setting and confirming IP address, DVI cable can be disconnected.