Louroe Electronics MS-1 - Manual (Page 2)

WIRING CONNECTION TO LOUROE BASE STATION OR AUDIO INTERFACE ADAPTER
CONNECTION BETWEEN LOUROE BASE STATION OR AUDIO INTERFACE ADAPTER
AND LOUROE MODEL MS-1
WIRING CONNECTION FROM LOUROE MODEL MS-1 TO MICROPHONE
On the back panel of Louroe Base Station or Audio Interface Adapter is a 3-pin terminal
block marked A, B, C.
A = 12Vdc
B = Audio Input
C = Ground
If using recommended or similar cable connect as follows:
1 Red wire connects to terminal A
2 Black wire connects to terminal B
3 Bare wire connects to terminal C
Using another set of recommended cable (West Penn 452 or equivalent) connect as follows:
1 Connect terminal B of MS-1 to terminal A of microphone
2 Connect terminal C of MS-1 to terminal C of microphone.
3 Connect terminal B of the microphone to terminal B of base station or audio interface
adapter using wire nut (mentioned previously).
The 3-pin terminal block of the Model MS-1 has been assigned with letters A, B, C (not shown on
actual board) for ease of installations.
1 Using recommended cable connect Red wire from terminal A of base station to terminal A of
MS-1
2 Connect Black wire from terminal B of base station to terminal B of microphone. Splice the
wires together using wire nut (see diagram on next page)
3 Connect Bare wire from terminal C of base station to terminal C of MS-1.
INSTALLATION AND OPERATING INSTRUCTIONS
Page 2 of 8
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: [email protected]
(818) ®
ms_1_inst_3/15