LD Systems MEI 1000 G2 - Manual (Page 8)

8
ENGLISH
DEUTSCH
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
ES
pA
ño
L
po
LSKI
IT
ALIAN
o
POWER
SET
2 2
3
4
1
1 LOW VOLTAGE CONNECTOR
Power supply connector for 12 - 18V DC (included).
2 BALANCED INPUT LEFT / RIGHT
Left and right-hand balanced inputs (XLR / 6.3 mm jack combo). In the mono mode, only the right input
(RIGHT) may be used.
3
PAD
Switchable level attenuation for high input level.
Switch in position -12 dB: Attenuation of the input signal by 12 db
Switch in position 0 dB: No attenuation of the input signal.
4 ANTENNA
TNC antenna connector 50 Ohm.
CONNECTIONS, CONTROLS, AND INDICATORS:
TRANSMITTER:
Rear panel
BELT CLIP
Clip the receiver to your belt or a suitable strap. For optimum fit, the
clip should always be pushed all the way over the belt and/or strap (see
illustration).
Battery replacement
To replace the batteries, press gently on the marked spots on the sides
of the battery cover and flip it forward. Remove the batteries, insert two
new AA-batteries (for orientation please see the illustration in the battery
compartment) and close the cover. Remove the batteries when the device
is not in use for an extended period.
BELT PACk RECEIVER