LD Systems MEI 1000 G2 - Manual (Page 10)

10
ENGLISH
DEUTSCH
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
ES
pA
ño
L
po
LSKI
IT
ALIAN
o
1
2
3
4
5
SYSTEM SETUp:
TRANSMITTER PROGRAMMING:
1 MAIN MENU
In the main menu the radio frequency, the operating mode (mono/
stereo) and signal level (AF L and AF R) are displayed.
2
SELECTING A FREQUENCY GROUP 1 - 8
Press the SET button repeatedly until "GROUP SELECT" appears in the
display. Press the keys to select the desired frequency group.
3
SELECTING A CHANNEL 1 - 12
Press the SET button repeatedly until "CHANNEL SELECT" appears
in the display. Press the keys to select the desired channel.
Note: For simultaneous operation of several systems, please make
sure that all the systems use different channels on the same
frequency group.
4
SELECTING THE OPERATING MODE
Press the SET button repeatedly until "MODE SELECT" appears in
the display.
With the buttons, you can now choose between mono and
stereo mode.
Select the mono mode if only one (mono)
audio signal is to be transmitted to the receiver. The signal is
located on two channels (left/right) of the receiver. In the mono
mode, only the right input (INPUT RIGHT) may be used.
Select the stereo mode if either a stereo signal, or two mono
signals are to be transmitted to the receiver.
Please refer to the notes in the Stereo and Focus Mode chapter.
5
LOCk AGAINST INADVERTENT CHANGES
Press the SET button repeatedly until "LOCK SELECT" appears in
the display. Press the keys to lock or unlock the system. If
"LOCK SELECT is enabled, the system settings can be viewed, but
not changed.
EXIT THE SETUP MENU
Press the SET button repeatedly until "EXIT SETUP" appears in the
display. Press the keys to exit the menu. If no control buttons are
pressed, the display switches automatically to the main menu after a
few seconds.