LD Systems MEI 1000 G2 - Manual (Page 15)

15
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
DEUTSCH
ENGLISH SETUP
For optimal transmission, position the transmitter at a minimum height of 1 m and point the antenna
upwards. If multiple wireless systems are used in an installation, please make sure
that the antennas do not touch or cross. Do not position the transmitter in the direct vicinity
of metal objects and digitally controlled devices (CD players, computers, digital consoles, etc.). Transmitter and
receiver should be within direct "line of sight" of each other.
TROUBLESHOOTING
PROBLEM DISPLAY SOLUTION
No sound or volume
too low.
Receiver: Display is switched off.
Make certain that the batteries are not dead
and the receiver is on.
Transmitter: Display is switched
off.
Check the connection between power supply
and transmitter. Turn on the transmitter.
Receiver: is on, but the RF indica-
tor is not lit.
Make certain that the transmitter and receiver
are set to the same radio frequency.
Reduce the distance between transmitter
and receiver and make certain that there
is a direct line of sight between transmitter
and receiver.
Make certain that the transmitter antenna is
installed correctly.
Receiver: is on and the RF indica-
tor is lit.
Increase the volume at the receiver and
check the headphone connection.
Check the input level on the transmitter and
increase it if necessary.
Distortion or noise. Receiver: RF indicator is on.
Increase the distance to possible causes of
interference (digitally controlled devices, e.g.,
CD players, computers, digital consoles…).
Use a different radio frequency.
Distorted sound.
Receiver: LOW BATT LED lights up Replace the batteries with new ones.
Transmitter: Level indicator is
too high
Lower the volume at the level controls of
the transmitter or at the source device.
SETTING UP AND TROUBLEShOOTING: