LD Systems MEI 1000 G2 - Manual (Page 7)

7
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
DEUTSCH
ENGLISH
POWER
SET
2
3
4
5
6 7
1
8
1
POWER-BUTTON
Switch on: Press and hold button for two seconds. Switch off: Press and hold button for two seconds.
2
ARROW DOWN BUTTON
See Chapter "System Setup".
3
ARROW UP BUTTON
See Chapter "System Setup".
4
SET (PROGRAMMING BUTTON)
See Chapter "System Setup".
5 LC DISPLAY
Backlit LC Display. See Chapter "System Setup".
6 INPUT LEVEL
Adjust the input sensitivity. In order to achieve an optimal signal to noise ratio, bring the input signal as close
as possible to the 0dB indicator (level indicator AF L and AF R in the display), without exceeding the distortion
limit (PEAK segment in the level meter).
7
HEADPHONE VOLUME CONTROL
Turning the knob to the left decreases the volume; turning it to the right increases the volume. To avoid
hearing damage, set the volume to minimum before using the earphones/headphones, then slowly increase
the volume. Caution: high volume can cause permanent hearing damage.
8
PHONES
Headphone output connector 6.3 mm stereo jack.
CONNECTIONS, CONTROLS, AND INDICATORS:
TRANSMITTER:
Front Panel