Delta 23-735 - Manual (Page 13)

13
OPERATIONS
IMPORTANT: KEEP SPARK GUARDS AND EYE
SHIELDS IN PLACE AT ALL TIMES.
Figures 23, 24, and 25, illustrate several typical
operations that can be accomplished using the grinder.
Each tool rest should be positioned a little below the
center of the grinding wheel and adjusted so the edge of
the tool rest is as close as possible to the grinding wheel
for maximum support to the piece that is being ground.
This is the most practical and safest position for general
work.
As the grinding wheel wears down to a smaller diameter,
readjust the tool rest closer to the grinding wheel. Always
maintain a distance of 1/8" or less between the grinding
wheel and the edge of the tool rest. Free hand grinding
without the use of the tool rest should always be done on
the lower quarter of the grinding wheel. Please read the
“SAFETY RULES” in the front of this manual and follow
them while operating this tool.
Fig. 23
Fig. 24 Fig. 25