Kussmaul Electronics 091-84-004 - Manual (Page 9)

KUSSMAUL
KUSSMAUL
ENGINE IDLER
VOLTAGE MONITOR
ON
LOW
OFF
HIGH
INSTALLATION AND WIRING DIAGRAM
IN
O
UT
SOURCE
BATTERY +
BRAKE
LIGHT
DIODE
On some vehicles install diode to
prevent emergency flasher or
turn signals from turning off the
engine idler
To +12 volts
thru accessory
position of
Ignition switch
Figure 4
1 amp fuse
VOLTAGE MONITOR & ENGINE IDLER
BRAKE SWITCH
FOR ENGINES WITH NEUTRAL SAFETY SWITCH CONNECTED TO STARTER
Starter
Solenoid
Connect 1N4004
as shown to suppress
starter solenoid transient
+12 volts from ignition switch
in "START" position
NEUTRAL
SAFETY SWITCH
CLOSED IN NEUTRAL OR PARK
NOTE:
Some engines have one
side of starter solenoid at
ground and the neutral
safety switch in the supply
side.
These must have a diode
installed across the starter
solenoid as illustrated.
This is particularly true of
FORD products
SEE NOTE:
VACUUM
ACTUATOR
091-84-VA
Stroke adjust
CHAIN,
CONNECT TO
THROTTLE LINKAGE
091-84-VV
SOLENOID
AIR VALVE