Kussmaul Electronics 091-84-004 - Manual (Page 3)

INSTALLATION
Typical installations are illustrated in figures 1 through 4. Mount actuator and solenoid valve
in an appropriate location and connect the actuator output to the throttle mechanism. (Note:
The actuator and solenoid valve must be purchased seperately. Kits that simplify the
actuator mounting and connection are available for several engines. Consult KECO sales
Department). Be certain that the ball chain or other coupling does not restrict throttle motion
at full closed throttle or wide-open throttle. Connect solenoid valve air lines and electrical
wiring as illustrated.
OPERATION
The High Idler receives its power from the ignition switch and functions only when the
ignition switch is either "ON" or in the ACC. position. High Idle is automatically disabled
under any of the following conditions:
1. Operator depresses the "OFF" pushbutton on the Engine Idler
2. Operator depresses the brake pedal
3. Operator places the transmission into Drive or Reverse
4. Operator turns off the ignition switch