Kussmaul Electronics 091-84-004 - Manual (Page 7)

KUSSMAUL
ENGINE IDLER
ON OFF
ENGINE IDLER INSTALLATION
To +12 volts
thru accessory
position of
Ignition switch
Figure 2
1 amp fuse
IN
O
UT
SOURCE
FOR ENGINES WITH NEUTRAL SAFETY SWITCH CONNECTED TO STARTER
NOTE:
Some engines have one
side of starter solenoid at
ground and the neutral
safety switch in the supply
side.
These must have a diode
installed across the starter
solenoid as illustrated.
BATTERY +
BRAKE
LIGHT
DIODE
On some vehicles install diode to
prevent emergency flasher or
turn signals from turning off the
engine idler
BRAKE SWITCH
Starter
Solenoid
Connect 1N4004
as shown to suppress
starter solenoid transient
+12 volts from ignition switch
in "START" position
NEUTRAL
SAFETY SWITCH
CLOSED IN NEUTRAL OR PARK
SEE NOTE:
VACUUM
ACTUATOR
091-84-VA
Stroke adjust
CHAIN,
CONNECT TO
THROTTLE LINKAGE
091-84-VV
SOLENOID
AIR VALVE