Machine use – Delta 36-865 User Manual

Page 16

Variable speeds from 10 FPM to 46 FPM are available
with the stock feeder. To change the feed rates, rotate
the knob (A) Fig. 39 until the desired feed rate is indicat-
ed by the pointer (B) on the knob.

NOTE: Each dot on the feed rate scale (C) will increase
or decrease the feed rate approximately 4 FPM.

The machine features a three-position directional switch
(Fig. 39). To change direction of feed, push either side of
the directional switch. To place the feed in “neutral”,
place the switch in the center position.

The stock feeder features a 1-1/4"

O.D. dust chute (A)

Fig. 40 for attaching a vacuum hose from a dust
collection system.

IMPORTANT: If you are using a dust collection system
with the stock feeder, use the following instructions. If
you are not using a dust collection system, disregard
these instructions.

Loosen the three screws, one of which is shown at
(B) Fig. 40, and remove the cover (C).

Use a flat-head screwdriver or similar tool to
carefully knock out the four individual plastic seg-
ments located at the bottom of dust chute (A) Fig.
40.

IMPORTANT: DO NOT

remove the cross-section (D)

Fig. 41. Replace the cover (C) Fig. 40.

You can rotate the entire feeder assembly (A) Fig. 38
360 degrees in the mounting bracket by loosening
the locking lever (B).

To raise or lower the feeder assembly (A) Fig. 38 ,
loosen the lever (C) and move the overarm (D).

To move the feeder assembly (A) Fig. 38 in or out,
loosen the locking lever (E) and rotate the T-handle
screw (F).

To adjust the position of the stock feeder (A) Fig. 38,
loosen the T-handle screw (G).

Tighten all the locking levers after all adjustments
are made.

IMPORTANT: If you are using a dust collection system
with the stock feeder, refer to the section “DUST
CHUTE”.

MACHINE USE

Fig. 38

ADJUSTING FEED RATES

CHANGING THE DIRECTION OF FEED

DUST CHUTE

DISCONNECT MACHINE
FROM THE POWER SOURCE.

Fig. 39

Fig. 40

Fig. 41