Delta 36-865 - Manual (Page 12)

12
9. Insert the end of the overarm assembly (B) Fig. 18 into the clamp assembly (M) until the gear inside the clamp
assembly meshes with the rack on the overarm. Turn the T-handle screw (S) counter-rclockwise until the clamp
assembly (M) is securely positioned on the overarm assembly (B).
IMPORTANT: Depending on the application, the overarm assembly (B) can be inserted into either end of the clamp
assembly (M).
10. Position three lockwashers and M10 hex nuts (T) Fig. 19, on the three screws, one of which is shown at (L). Tighten
all of the overarm clamp-mounting hardware.
11. Align the threaded hole in the swivel joint (V) Fig. 20 with the threaded bolt (W). Attach the swivel joint to the over-
arm clamp assembly (M) by turning the lever (X) clockwise. Fig. 21 illustrates the swivel joint (V) attached to the
overarm clamp assembly (M). Attach the base (Y) Fig. 22 to the swivel joint (V) in the same manner. Snug-up the
locking handle (Z).
12. Fig. 23 illustrates the Versa-Feeder TM attached to the overarm assembly.
B
L
M
S
F
L
T
X
M
W
V
M
V
Y
Z
V
Fig. 18 Fig. 19
Fig. 20
Fig. 21
Fig. 22 Fig. 23