Kreg KFT4X8 Face-Framing Table - Manual (Page 8)

R
Operating Instructions - Squaring the Fence 7.
Squaring the Fence
The squaring fence serves as a general reference to keep your
workpieces aligned prior to assembly. It comes calibrated from
the factory with a basic carpenters square. It should be noted
that the most important aspect of making sure your frames
turn out square and fl ush is by assuring that your workpieces
are cut square and true prior to assembly. Simply put, if your
workpieces are not square prior to assembly, your frame will
not be square once
assembled. The squaring fence features set screws that allow
it to be easily re-calibrated if knocked out of alignment.
To re-align squaring fence:
1) Place carpenter’s square on base of table
2) Loosen locking nuts
3) Adjust allen screw inward or outward to re-square fence
4) Re-tighten locking nut
Figure 2
Figure 3
Figure 4
Figure 1
Loosen locking nuts with hex wrench, and adjust the set
screws with an allen wrench to square fence.
Re-tighten locking nut once complete.
Place carpenter’s square on base of table and check for gap.
Adjusting the set screw.