Kreg Precision Band Saw Fence - Manual (Page 7)

Assembly
6.
Insert the T-shaped stem of the lens cursor into the clamp block, letting
the entire lens body protrude beyond the edge of the clamp block.
Secure the lens cursor with the #10-32 x
1 ⁄
4
" nylon screw.
Thread two #10-32 x 3 ⁄
8
" nylon set screws into the the rear corner
holes in the clamp block. Adjust the set screws to protrude 1 ⁄
16
" below
the bottom surface of the block. These screws act as glides to provide
smooth fence movement.
Thread two 1 ⁄
4
"-20 x 3 ⁄
4
" nylon socket head screws into the front corner
holes in the clamp block until the ends of the screws are fl ush with the
bottom surface of the block.
Slip a 5 ⁄
16
" brass washer on each of the 5 ⁄
16
" x 3 ⁄
4
" hex head bolts, insert
them through the fence bracket, and thread them into the clamp block.
Make sure the large hole in the fence bracket aligns with the rear hole
in the clamp block. Align the fence bracket square with the clamp block
and tighten both bolts.
Thread the lock knob into the front face of the clamp block until the
swivel pad protrudes
1 ⁄
16
" beyond the inside surface. Position the clamp
block assembly on the mounting rail and lightly tighten the lock knob to
hold the assembly in place.
Assemble the Clamp Block
Insert the head of each 1 ⁄
4
"-20 x 2 1 ⁄
2
" hex head bolt into the T-slot in
the back of the fence extrusion. With one bolt in each U-shaped fence
bracket upright, position the fence extrusion against the bracket with
the bottom edge resting on the saw table. Slip a
1 ⁄
4
" brass washer onto
each bolt and thread on a T-knob.
Test the operation of the Precision Band Saw Fence by sliding it from
side to side along the mounting rail.
Tip
To obtain smooth right-to-left fence movement, tighten the lock knob to
square the clamp block with the mounting rail. Then loosen the knob
just enough to allow the fence to slide.
Attach the Fence Extrusion
Lens cursor
Fence bracket
#10-32 x 1/4"
Nylon screw
#10-32 x 3/8"
Nylon set screw
Lock knob
1/4"-20 x 3/4"
Nylon socket
head screw
5/16" Brass washer
5/16 x 3/4" Hex head bolt
Clamp block
T-knob
Fence extrusion
Fence bracket
Lock knob
1/4" Brass washer
1/4" - 20 x 2-1/4"
Hex head bolt