beautypg.com

Vertex Standard VX-264 User Manual

Page 9

background image

VX-264 O

perating

M

anual

7

b

eFore

Y

ou

b

egin

battery pack. If charging with the transceiver attached,

turn the transceiver off. The antenna jack should be at

the left side when viewing the charger from the front.

r

If the battery pack is inserted correctly, the LED in-

dicator will glow red. A fully-discharged battery pack

will charge completely in 1.5 - 3.0 hours (depending

on the battery pack being charged).

r

When charging is completed, the LED indicator will

change to green.

r

Disconnect the battery pack from the CD-58 Desktop

Charger and unplug the PA-55 AC Adapter from the

AC line outlet.

1) Always use the Vertex Standard FNB-V133LI-

UNI or FNB-V134LI-UNI Lithium-Ion Battery

Pack.

2) Use only the Vertex Standard CD-58 Desktop Charger

and the Vertex Standard PA-55 AC Adapter.

3) To reduce the risk of explosion, recharge the batteries

outside of hazardous locations.

4) Perform the battery charging where the ambient tem-

perature range +41 °F to +104 °F (+5 °C to +40 °C).

Charging outside of this temperature range could cause

damage to the battery pack.

5) Battery Pack should not be exposed to excessive heat

such as sunshine, fire, or similar heat sources.

6) Risk of explosion exists if battery is replaced by an

incorrect type. Refer to the enclosed instructions for dis-

posal of used batteries.

7) For further details and cautions of the charging, refer

to the Operating Manual of the CD-58 Desktop Charger.

Low.Battery.Indication

As the battery discharges during use, the voltage gradually

becomes lower. When the battery voltage becomes too

low, substitute a freshly charged battery and recharge the

depleted pack. The LED indicator on the top of the radio

will blink red when the battery voltage is low.
You may confirm the battery condition by the Battery

Icon on the display. See page 11 for more information.

CAUTION

Danger of explosion if battery is replaced with an

incorrect battery. Replace only with the same or

equivalent type.