Motorola DR 3000 - Manual (Page 20)

Chapter 5 Post-Installation Checklist
After the MOTOTRBO Repeater has been mechanically installed and all electrical connections have
been made, power may now be applied and the repeater checked for proper operation.
5.1 Applying Power
Before applying power to the repeater, make sure all boards are securely seated in the appropriate
connectors on the backplane and that all RF cables are securely connected.
Turn ON the circuit breaker controlling the AC outlet that is supplying power to the repeater Power
Supply Module.
5.2 Verifying Proper Operation
Operation of the repeater can be verified by:
• observing the state of the 8 LEDs located on the front panel, and
• exercising radio operation.
5.2.1 Front Panel LEDs
After turning ON the repeater power (or after a repeater reset), the 8 LEDs on the repeater front
panel:
• are all lit for about one second to indicate that they are functional.
• go off for one second.
• now indicate operational status of the repeater.
5.3 Archiving
5.3.1 Copying the Repeater Codeplug Data to a Computer
Backup the repeater's codeplug data by using the Customer Programming Software (CPS) on a
computer.
Some repeater components can become extremely hot during operation. Turn
off all power to the repeater, and wait until sufficiently cool before touching the
repeater.
!
C a u t i o n