Kleenmaid KED501 - Manual (Page 13)

130716
- End of drying procedure
At the end of the drying procedure the (F)
LED flashes, indicating that the drying
program has ended. Signal (E) LED clean
the filter is on.
•
Open the dryer door by pushing the left-hand side
of the door towards the appliance.
•
Remove the laundry from the dryer.
•
Turn the appliance off by turning the jog selector
(A) to the position “0”.
•
Clean the lint filter (see chapter on Cleaning and
Maintenance).
•
Close the dryer door.
•
Turn the appliance off by turning the jog selector
(A) to the position “0”.
•
Pull the power lead from the socket and cut the
power supply from the mains.
•
By the user
After drying be careful when extracting
laundry from the appliance, as it may be
hot!
Suspending the operation by pressing the
START/PAUSE button.
In case you press the START/ PAUSE button (D)
during the drying procedure, the drying program is
suspended, and with the next press of the same
button the program is resumed where it had been
interrupted.
Changing the program or the functions
If you wish to change the drying program or the
additional functions during the drying procedure,
move button (A) to the position “0”, select new
drying program or additional functions and confirm
13
Interruptions