Kleenmaid KED501 - Manual (Page 12)

130716
After drying is completed, this function
returns to the initial higher temperature.
Turning the anti-crease program off
The anti crease program is active at the end of
the program and will remain active for one hour
(occasionally turning the drum).
Press the (C) button to turn off the anti crease
program; the LED above the button is on.
If the program has been turned off, the LED above
the (C) button remains on at the end of drying cycle.
If the anti-crease function is on the LED above the
(C) remains off. The (F) LED will also flash in both
instances.
When the dryer is turned off, this function
is reset; the anti crease program is on.
•
Drying process is turned on by pressing the
START/PAUSE button (D); the (H) LED is
permanently lit.
•
If you turn the program selector jog during the
drying process, settings do not change, except at
the position 0, whereby the program is suspended.
•
When the set moisture level is reached, the
cooling process starts; the (H) LED goes off and
the (G) LED is on.
•
If the Airing program is selected (see drying
programs table) the (G) LED is on throughout the
entire program.
•
Cooling off period lasts 10 minutes; LED (G) is on.
•
Program is suspended if the drum sensor fails to
detect laundry in the drum.
•
The anti-crease program is active at the end of
program and remains active for 1 hour (drum
occasionally spins around).
•
If you open the drum door after the drying cycle
had been completed, the anti-crease program is
ended.
1
Drying procedure