Kleenmaid ZSGS420IBS - Manual (Page 16)

Use Rear Holes
to Secure Trim
Use Front Holes
to Secure Handle
Installation Instructions
16
STEP 10A INSTALL OVERLAY PANELS
Custom handles
If you are using custom handles, the handle must be
properly secured to the panel before sliding the panel
into the trim.
• The cabinet manufacturer will supply the custom
handle and hardware.
• Secure the door trims using both the FRONT and
REAR screw holes. Use pan head screws to secure the
trim. A package of 12 extra pan head screws can be
found in the literature package. Discard supplied
handles.
Install door panels:
• Open door to 90°. Remove the 6 Phillips head screws
from the door handle.
• Remove handle. Retain all screws.
• Remove 6 screws holding trim, lift off trim. Retain
screws.
• Slide overlay panel into the door trim.
Dispenser Models Only:
• The dispenser controls protrude beyond the face of
the freezer door. To avoid damage to the dispenser,
the trim at the top of the door should be removed.
• Remove the screws holding the top trim in place.
• Place the assembled freezer panel into the bottom
channel and slide into the hinge side trim.
• Reinstall the top trim piece with screws.
• There are two sets of holes in the handle side trim.
Replace handle side trim by installing the original
screws in the REAR screw holes.
• Secure the handle to the door using the FRONT
screw holes.
• Follow the same procedures to install the opposite
panel.
• Check to be sure handles are evenly aligned with
each other at the top. To adjust, loosen handle
screws and slide up or down. Tighten screws.
Supplied Handle
Shown in Overlay
Panel Position
Refrigerator
Door
Door Trim
Handle
Trim
Move
Forward
For 19 mm
Panel