Kleenmaid OCCTWB - Manual (Page 12)

A S S E M B L Y – G E N E R A L 12 12
TEST FOR LEAKS WITH A
SOAP SOLUTION, NEVER WITH AN
OPEN FLAME (Refer to pages 4 and 5).
CONNECTING TO, AND DISCONNECTING
FROM GAS SOURCE
CONNECTING TO GAS SOURCE
1. Place gas cylinder into the gas cylinder tray and face the
gas cylinder valve to the left rear corner. Secure with
wing bolt.
2. Attach cylinder connection
device of regulator and hose
assembly to cylinder
valve outlet.
Tighten firmly.
3. Open gas cylinder
valve fully to allow
gas to flow.
4. Leak test all accessible
connections thoroughly
using a soapy water
solution prior to lighting the appliance.
Refer to Safety information, pages 4 and 5.
5. If a leak is found, turn gas cylinder valve off and do not use
appliance until repairs or replacement can be made.
DISCONNECTING FROM GAS SOURCE
1. Turn burner control ‘OFF’.
2. Turn gas cylinder valve off fully.
3. Detach regulator assembly from gas cylinder valve.
This appliance is also certified for use on natural gas. Contact
the manufacturer for advice in relation to using this appliance on
natural gas.
Refer to back cover.
Appliances for use on natural gas must be installed by an
authorised person.
NATURAL GAS INSTALLATION
IMPORTANT: Before connecting and disconnecting
appliance to gas source, ensure burner controls are
in ‘OFF’ position.
NOTE: The ‘OFF’ position on the control panel is
identified by either a small black dot / a short vertical
black line / or the word ‘OFF’.
When the marking, or the word ‘OFF’ printed on
the control knob, aligns with the printed marking on
the control panel, then the burner is in the fully off
position.
CAUTION: When the appliance is not in use, the gas
must be turned off at the gas cylinder.
Familiarise yourself with the general information and safety
guidelines located at the front of this booklet. Check to see that
gas cylinder is filled and that end of each burner tube is properly
located over each valve orifice. Set burner controls to
‘OFF’
position.
ENSURING BURNER CONTROLS ARE OFF
• DISCONNECT AND REMOVE GAS
CYLINDER WHEN MANOEUVRING
APPLIANCE OVER UNEVEN SURFACES
OR CARRYING UP AND DOWN STAIRS.
• IF THIS INFORMATION IS NOT
FOLLOWED EXACTLY, A FIRE
CAUSING DEATH OR SERIOUS INJURY
MAY OCCUR!
• DO NOT STORE A SPARE GAS
CYLINDER UNDER OR NEAR THIS
APPLIANCE.
• THIS APPLIANCE IS ONLY TO BE
USED OUTDOORS.
Direction for
tightening