Kleenmaid OCCTWB - Manual (Page 11)

I N S P E C T I O N 11 11
Ensure gas source is turned off or is disconnected and all burner
control knobs are set to
‘OFF’. Open the lid and remove the hot
plate. Push the electronic igniter. You should hear a ‘clicking’
sound. You should see a blue spark within the gas collector
box. If a spark is present the electrode tips are properly positioned.
If no spark is seen, the spark gap needs to be
adjusted as follows:
•
Using an adjustable spanner, loosen the inside nut until the
gas collector box can be turned upward. If the gap between
the spark electrode tip and receiver is more than 4 - 5 mm use
long nose pliers to gently squeeze the gas collector box to
narrow gap. Return the gas collector box to its original
position, secure the inside nut and try the electrode check
again.
• CHECK PERFORMANCE OF
BURNERS PRIOR TO INSTALLING
HOT PLATE COMPONENTRY.
Refer to page 14 for lighting instructions.
• DO NOT SMOKE WHEN ATTEMPTING
TO IGNITE APPLIANCE.
• NEVER USE VOLCANIC ROCK,
HEAT BEADS OR OTHER MATERIAL.
• ALWAYS USE PROTECTIVE GLOVES
WHEN HANDLING HOT COMPONENTS.
• Open pot burner lid.
• Push electronic ignition button. Look for a spark between tip
of electrode and burner.
• If you don't see a spark from pot burner electrode, adjust
gap between electrode and burner surface to 4 - 5 mm.
ELECTRODE CHECK – POT BURNER
This test will ensure the spark electrode tips are correctly positioned
so the appliance lights easily and properly.
ELECTRODE CHECK – HOT PLATE BURNER
+
-
4-5 mm
spark gap Gas collector
box
Spark
electrode tip
Spark
receiver
Inside
nut
• Unscrew igniter cap from control panel.
• Place supplied AA battery into the igniter slot with positive
pole facing you.
• Position the cap and spring over the AA battery and tighten
onto control panel.
INSTALL IGNITER BATTERIES
AA
battery
Spring
Igniter
cap
Contact