Kleenmaid ICK68X - Manual (Page 29)

29
Check whether the saucepan is ferromagnetic
(attracts a magnet). Check whether the diameter
of the saucepan is large enough.
Allow the saucepan to cool down in the event
that it has become too hot when used.
If the display still does not light up when you switch
the hotplate off and on again, disconnect
the appliance from the mains. Wait 20 seconds
and then reconnect it.
The powerboost function operates the hotplate
with the most possible power. During long cooking
times, it is possible that the function will switch
the hotplate off to protect the hob from overheating.
You can continue to use the hob if the display
is not flashing.
Repairs may only be carried out by trained
customer service personnel.
Incorrect repairs to the appliance may expose
the user to increased risks.
If E Ö and E with a figure numbers appear
in the display panels, there is a fault in the electronics.
Disconnect the appliance from the mains and
reconnect it. Consult the afterĆsales service
if the display appears again.
If F and a number flash alternately in the display, your
appliance is indicating a fault. The following table
contains measures for rectifying faults.
Visual
indication Fault Measure
F0 An internal error was
produced while the hob
was working. Disconnect the cooking hob from the mains. Wait a few
seconds before connecting it again.
If the symbol continues to appear contact the technical
assistance service.
F2 The cooking hob is too hot
and has turned off. Remove the cookware from the front cooking zones. F2 it
is turned off by touching the control surface if the hob has
cooled down sufficiently.
The display flashes (there
is no power) when you
place a saucepan on an
induction hotplate
The powerboost function
display flashes and then
switches off
Repairs
d
Indication E Öand E with a
figure
F display and numbers