Kleenmaid S9 February 2006 - Manual (Page 14)

Instructions for the installer
14
The unit must be coated in heat-resistant material (minimum 90°C). If the appliance is installed
close to other units, the minimum space suggested in the following diagram must be left.
Any adjoining wall surface situated within 200mm from the edge of any hob burner must be a
suitable non-combustible material for a height of 150mm for the entire length of the hob. Any
combustible construction above the hotplate must be at least 600mm above the top of the burner
and no construction shall be within 450mm above the top of the burner.
Where the distance from the edge of any burner to a horizontal surface is less than 200mm, the
surface must be either: 10mm (min) below the level of the hob, or have the vertical component of
the surface suitably covered with a non-combustible material as specified in AS 5601 - AG 601.
3.9 Gas adjustments
For cooktops, the Data Label is located on the underside of the appliance. A duplicate label is
supplied to adhere in an accessible area adjacent to the appliance. For cookers, the label is
situated in the appliance drawer. This appliance is suitable for Natural Gas and Propane; ensure
that the available gas supply matches the Data Label.
If the cooking appliance is set up for a different type of gas than that available, its injectors must be
replaced, the minimum flow regulated and the rubber-holder changed. In order to replace the
injectors in the cooking hob, it is necessary to carry out the following operations:
• remove the grids;
• remove the burners and burner caps (Fig. A);
• take out the injector (Fig. B) and replace it with one
suitable for the new type of gas (see "G ENERAL
INJECTORS TABLE ");
• replace the gas label (on the rear of the appliance) with
the new one provided with the injectors kit;
• refit all parts by following the disassembly instructions in
reverse order and taking care to position the burner cap
correctly on the burner.