Kleenmaid CC29 - Manual (Page 9)

CONTROL PANEL OPERATION
3. CONTROL PANEL OPERATION
3.1 Gas Burner Controls (CG Models)
The cooktop burners are ignited by the in-built electronic ignition controls. The controls must be turned anti-
clockwise to operate and can only be turned clockwise to the off position. Alternatively the burner may be ignited
manually using matches, cooktop gas lighters or similar devices, being careful not to risk injury or damage.
To operate the controls ensure the burners are correctly assembled and positioned over the gas burner outlets
and the pan supports are correctly positioned then:-
a) Start the gas flow by pressing down and turning the control knob corresponding to the burner you wish to
use. Pressing down on the control knob causes the igniter to spark.
NOTE: For models CG29, CG29WOK, CG60WOKFFE, CG90WOKFFE
These units are fitted with Flame Failure Safety Devices. These require the controls to be fully depressed
during ignition to ensure correct operation. The controls should be held fully down for at least 10 seconds
during the ignition and flame establishment period to ensure the valve remains open after the knob is
released.
b) Once the flame is established the knob need no longer be pressed and may be turned to your required
setting.
Check for a clear blue flame without excessive yellow tipping. If burners show any abnormal combustion check
they are correctly located on the burner base. Sometimes burners may not ignite immediately and may seem to
‘‘blow’’ slightly when they do ignite. This is usually due to air in the gas line, which should clear itself.
If, after following the instructions, satisfactory performance cannot be obtained, contact the local gas authority
for advice and assistance.
For minor adjustments see Servicing and Minor Adjustments.
A 2 yearly inspection of the appliance by an authorised service agent will ensure many years of trouble free
service. (Note: This is not provided under warranty).
7