Kleenmaid CC29 - Manual (Page 26)

CABINET INSTALLATION INSTRUCTIONS
6.5 Securing the Cooktop
For gas appliances, the final gas connection shall be made using a flexible hose or annealed copper tubing of
sufficient length to permit the insertion and removal of the appliance. For gas appliances connected using flexible
hose, hose to be type A, 65
°
C rated with 1 / 2
″
BSP connections.
For appliances fitted with flexible electrical lead and plug, the general purpose outlet and switch must not be
installed within the appliance recess and must be readily accessible without having to remove the appliance.
The unit must be securely clamped to the benchtop once correctly positioned. Refer to the diagrams below for
the relevant models.
All Models
Clamping Cooktop to Benchtop Surface
UNIT SHOWN CLAMPED TO
24mm BENCHTOP.
— USE SECOND SLOT IN
BRACKET FOR THICKER TOPS.
Domino Models
When two or more models are installed together they can
be attached on the underside by the connector plates and
screws supplied. Alternatively a 15mm bar can be left
between the individual cutouts and the larger clamps used.
When butting two or more models together, a strip of foam
is supplied, which can be attached to one edge as shown.
When two or more models are installed together, allow
15mm between each cutout, i.e. for the two gas models the
cutout is 275mm each plus 15mm giving a cutout of 565mm
wide x 515mm front to back.
24