Kemppi 5001 Master - Manual (Page 13)

MASTER 5001/0541 – 13 ©
KEMPPI OY
Loss of a phase in the mains supply
Loss of a phase causes noticeably poorer welding properties than normally or the machine doesn´t
get started at all. Loss of a phase can be due to following:
- blowing of mains supply fuse
- defective mains cable
- bad connection of mains connection cable on terminal block or plug of machine.
6. DISPOSAL OF THE MACHINE
Do not dispose of electrical equipment together with normal waste!
In observance of European Directive 2002/96/EC on Waste Electrical and Electronic
Equipment and its implementation in accordance with national law, electrical equipment
that has reached the end of its life must be collected separately and returned to an
environmentally compatible recycling facility. As the owner of the equipment, you should
get information on approved collection systems from our local representative.
By applying this European Directive you will improve the environment and human
health!
7. ORDER NUMBERS
Master 5001 6130512
20/5 m 50mm² 6184511
20/5 m 70mm² 6184711
21/5 m 50mm² 6184501
21/5 m 70 mm² 6184701
C100C 6185410
C100D 6185413
16c/10 m 6185451
/25 m 6185452
/50 m 6185453
T12 6185228