Kemppi Master MLS MEX panel - Manual (Page 9)

Master MLS MEX / 0241 – 9 ©
COPYRIGHT KEMPPI OY
Proceed as follows:
1. Press MEMORY button twice and if the SET light starts blinking,
the channel is free. If the channel is in use the led will remain lit.
2. Select memory channel by pressing CH button.
3. Select the parameters and press SAVE button.
4. Press MEMORY button twice. ON led is lit.
5. Start welding and adjust settings if necessary.
If saved settings need to be changed, the led has to be moved from ON into SET
position in order to select parameters. Press the SAVE button. It is also possible
to save the currently used parameters in the panel by pressing SET when the
memory function is in off state (no lights on). Channel is cleared if MEMORY
and CH buttons are pressed simultaneously in SET mode.
The saved settings are taken into use as follows:
1. Select MEMORY by pressing the button.
2. Select memory channel by pressing CH button.
3. Start welding.
Remote control of memory channels is accomplished as follows:
Memory channels are selected by pressing simultaneously both REMOTE and
CH button. With the remote control you can retrieve saved settings on memory
channels.
3.9. SETUP, PRESET VALUES OF WELDING PARAMETERS
MEX panel has special MMA-MEX Setup functions. Press
REMOTE (SETUP) button (8) longer than normally to
enter (or exit) the Setup mode. You can select the functions
(see list below) by pressing the arrow buttons and then
change the settings by turning the potentiometer.
FUNCTION NUMBER FACTORY SETTING
Hot start adjustment method: 1 knob or 2 knob A1 0 2 knob
Antifreeze on/off in TIG A3 0 off
Antifreeze on/off in MMA A4 1 on
Adaptive hot start on/off A5 0 off
No load voltage selection 80V / 40V A7 0 80V
Function of hand remote (normal remote current
regulation of MMA/TIG changeover) A12 0 normal