Kemppi Master MLS MEX panel - Manual (Page 5)

Master MLS MEX / 0241 – 5 ©
COPYRIGHT KEMPPI OY
1.3. OPERATION SAFETY
Please study these Operation safety instructions and respect them when install-
ing, operating and servicing the machine.
Welding arc and spatters
Welding arc hurts unprotected eyes. Be careful also with refl ecting arc fl ash.
Welding arc and spatter burn unprotected skin. Use safety gloves and protective
clothing.
Danger for fi re or explosion
Pay attention to fi re safety regulations. Remove fl ammable or explosive materials
from welding place. Always reserve suffi cient fi re-fi ghting equipment on welding
place. Be prepared for hazards in special welding jobs, e.g. for the danger of fi re
or explosion when welding container type work pieces. Note! Fire can break out
from sparks even several hours after the welding work has been fi nished!
Mains voltage
Never take welding machine inside a work piece (e.g. container or truck). Do
not place welding machine on a wet surface. Always check cables before operat-
ing the machine. Change defect cables without delay. Defect cables may cause
an injury or set out a fi re. Connection cable must not be compressed, it must not
touch sharp edges or hot work pieces.
Welding power circuit
Isolate yourself by using proper protective clothing, do not wear wet clothing.
Never work on a wet surface or use defect cables. Do not put hot electrode or
welding cables on welding machine or on other electric equipment.
Welding fumes
Take care that there is suffi cient ventilation during welding. Take special safety
precautions when welding metals which contain lead, cadmium, zinc, mercury or
beryllium.
2. INSTALLATION
2.1. INSTALLATION INSTRUCTIONS
2.1.1. MEX delivery package contains
A. MEX control panel
B. This operation manual