Kemppi MXF 63 - Manual (Page 5)

EN
1. PREFACE
1.1 General
Congratulations on choosing the FastMig MXF equipment. Used correctly, Kemppi products
can significantly increase the productivity of your welding, and provide years of economical
service.
This operating manual contains important information on the use, maintenance and safety of
your Kemppi product. The technical specifications of the equipment can be found at the end
of the manual.
Please read the operating manual and the safety instructions booklet carefully before using
the equipment for the first time. For your own safety and that of your working environment,
pay particular attention to the safety instructions in the manual.
For more information on Kemppi products, contact Kemppi Oy, consult an authorised Kemppi
dealer, or visit the Kemppi web site at www.kemppi.com.
The specifications presented in this manual are subject to change without prior notice.
Important notes
Items in the manual that require particular attention in order to minimise damage and
personal harm are indicated with the ’ NOTE! ’ notation. Read these sections carefully and follow
their instructions.
Disclaimer
While every effort has been made to ensure that the information contained in this guide
is accurate and complete, no liability can be accepted for any errors or omissions. Kemppi
reserves the right to change the specification of the product described at any time without
prior notice. Do not copy, record, reproduce or transmit the contents of this guide without
prior permission from Kemppi.
1.2 About FastMig products
Kemppi FastMig™ MXF 63, MXF 65 and MXF 67 are wire feeders designed for demanding
professional use. MXF 63 is intended for 200 mm wire spool, MXF 65 and MXF 67 for 300 mm
wire spool. Wire feeders can be used with FastMig Pulse, FastMig KMS and FastMig M power
sources.
Which alternative panel to choose for MXF 63, 65 and 67 depends on the used power source
i.e. FastMig KMS becomes compatible by connecting SF 51, SF 52W, SF 53W or SF 54 control
panels with MXF wire feed unit, and in the case of PF 63 and PF 65 control panels FastMig
Pulse power source can be connected. With FastMig M the MR 200, MR 300, MS 200 or MS 300
panels are used. Operation of wire feed units is controlled and adjusted by microprocessor. By
adding an optional synchronization unit (MXF Sync 65), SuperSnake sub-feeder device may be
connected to MXF 63, 65 and 67.
This manual provides instructions on the start-up and use of the MXF 63, 65 and 67 MIG/MAG
wire feeding units.
3
© Kemppi Oy / 1515