Kemppi MXF 63 - Manual (Page 15)

EN
2.15 Main switch I/O
When you turn the main switch of the FastMig power source into I-position, the pilot lamp
closest to this switch will illuminate, indicating the power source is ready for welding. The
equipment will return to the operation state as before the main switch was turned to the zero
position.
Always start and switch off the machine with the main switch, never use the mains plug as a
switch.
2.16 Operation of cooling unit, FastCool 10
When FastCool 10 is connected to the FastMig power source for the first time, the cooler
function is normally active. To deselect the cooler function, follow the instructions below
depending on the power source type in use.
FastMig KMS and FastMig M
When leaving the factory, cooling unit status is set 'ON'. If no cooling unit is connected, set the
cooling unit status to 'OFF'. Depending on your panel type follow the instructions described
in the graphic below. Having selected the cooling state required, reset the power source by
switching off at the main on/off switch. Restart the power source and weld.
SF 51/SF 54
WIRE INCH
weld
data
V A
m/min
4T
SETUP
2T
U
MMA
MIG
MMA
PANEL
SF 51
W001318
DYNAMICS
ARC FORCE
GAS TEST
GAS TEST
ARC FORCE
DYNAMICS
GAS TEST
ARC FORCE
DYNAMICS
MR 200/MR 300
13
© Kemppi Oy / 1515