Kemppi MXF 63 User Manual
Page 28
EN
5.6 MR 200 and MR 300 control panel for FastMig M
For full operational descriptions for MR 200 and MR 300 control panels refer to the digital
storage device delivered with the product.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. 11.
1.
ON/OFF button
2.
a) Wire feed speed/welding current display
b) Selected SETUP entry display
3.
MIG dynamics/MMA Arc Force selection
4.
Selection of air/liquid cooled MIG gun
5.
Weld data: Last used welding parameters shown in displays
6.
a) Welding voltage display
b) Adjustable parameters display
7.
Selection of MIG/MMA process
8.
a) Selection of switching logic: 2T/4T
b) Long press: Setting the basic parameters (SETUP)
9.
a) Adjustment of wire feed speed
b) Adjustment of MMA current
c) Selection of SETUP parameter
10. a) Adjustment of welding voltage
b) Adjustment of MIG dynamics
c) Adjustment of SETUP parameters
11. Manual control/remote control unit selection
NOTE!
With MR 200 and MR 300 panels 'Wire Inch' and 'Gas Test' buttons should be used from
inside the wire feed unit.
FastMig MXF 63, 65, 67
26