Kemppi MXF 63 - Manual (Page 17)

EN
3.1 Connecting and mounting
Fasten the ribbon cable connector from the MXF wire feed unit to the control panel. Attach
the yellow-green earth lead into the fork connector on the PF panel.
MXF 65
1. 2.
1. Place the bottom edge of the panel behind the securing clips on the machine. Remove the
fixing pin from the top edge with, for example, a screwdriver. Then gently push the
upper part of the panel into place. Make sure that the cables do not get damaged,
continue gently pushing the upper part of the panel until it clips into place.
2. Finally secure the panel into place with the additional black plastic security clip provided
(MXF 65 only). Ensure that the clip is positioned correctly. You will notice that the clip
does not seat snuggly if its positioned upside down.
MXF 63 + MXF 67
MXF 63 MXF 67
+
15
© Kemppi Oy / 1515