Kawai CA17 - Manual (Page 6)

6
� Doing so may cause the product to become
deformed or fall over, resulting in breakdown
or injury.
Do not stand on the product or exert
excessive force.
� Doing so may result in discoloration or deformation
of the product.
�
When cleaning the product, put a soft cloth in
lukewarm water, squeeze it well, then wipe the
product.
Do not wipe the product with benzene
or thinner.
Failure to do so may damage them, resulting in
fire, electric shock or short-circuit.
When connecting the AC power cord
and other cords, take care
not to get them tangled.
� Doing so may cause the product to generate
noise.
�
If the product generates noise, move the
product sufficiently away from the electrical
appliance or connect it to another AC outlet.
Do not place the product near electrical
appliances such as TVs and radios.
Please lift up the product when moving it.
Please note that the product is heavy and must
be carried by more than two persons.
Dropping the product may result in breakdown.
Do not drag the product on the floor.
Take care not to drop the product.
Doing so may cause the illumination to fall over,
resulting in fire.
Do not place naked flame, such as lighted
candles on the product.
CAUTION Indicates a potential hazard that could result in injury or
damage to the product or other property if the product
is handled incorrectly.
Using the product in such areas may result in
product breakdown.
Use the product only in moderate climates (not
in tropical climates).
Do not use the product in the following areas.
�
Areas, such as those near windows, where the product is
exposed to direct sunlight
� Extremely hot areas, such as near a heater
� Extremely cold areas, such as outside
� Extremely humid areas
� Areas where a large amount of sand or dust is present
� Areas where the product is exposed to excessive
vibrations
Closing it roughly may trap your fingers,
resulting in injury.
When you close the keyboard cover,
close it gently.
Failure to do so may cause breakdown of this
product and other devices.
Before connecting cords, make sure
that the power to this product
and other devices is turned
OFF.
OFF
The product should be located so that its location or position does not interfere with its proper ventilation. Ensure a
minimum distance of 5cm around the product for sufficient ventilation.
Failure to do so may over-heat the product,
resulting in fire.
Ensure that the ventilation is not
impeded by covering the ventilation
openings with items, such as newspaper,
table-cloths, curtains, etc.
Use only the AC adaptor included with this instrument to power the instrument.
�
Do not use other AC adaptors to power this instrument.
� Do not use the included AC adaptor or AC power cord to power other equipment.