Kawai CA17 - Manual (Page 48)

48
A
pp
en
di
x
Assembly Instructions
3. Mounting the main body onto the stand
Ensure that two or more people undertake the
following step of the assembly process.
Lift the main body and carefully place it onto the stand.
Position the main body towards the front of the stand, so
that the metal fitting holes are visible when viewed from
above.
Gently slide the main body backwards until the base
engages with the stand fixings and locks into place. When
positioned correctly, the attachment screw holes should
be visible from the underside of the main unit.
* If the screw holes are not visible, re-adjust (loosen) the screws
attached in step 2-4.
When lifting the main body onto the stand, be
careful not to catch/trap hands and fingers.
A
C
B
A
4. Fastening the main body to the stand
View the front of the instrument to ensure that the main
body and side panels are in alignment.
* If the parts are not in alignment, re-adjust (loosen) the screws
attached in step 2-4.
Loosely fasten the front of the main body to the stand from
below, using two screws (with washer) on either side.
Loosely fasten the rear of the main body to the stand from
below, using the remaining two screws (with washer) on
either side.
When all four screws are attached and the main body is
correctly positioned on top of the stand, securely tighten
all screws.
Tighten all screws securely to ensure that the
main body is firmly attached to the stand.
C
A
A
Front view
B