Getting to know your kanguruclone hd – Kanguru Clone 4HD User Manual
Page 6
KanguruClone HD
- 6 -
CHAPTER 2
Getting to Know Your KanguruClone HD
Hardware Setup
1. Before plugging in the AC Power Cable, please make sure that the voltage
is adjusted to the same as your local voltage 110V/220V.
2. The unit is designed to hold the Master drive in the bay located on the left
side of the unit. Before connecting the Master drive, make sure that the
jumpers are set to either MASTER or CABLE SELECT. You may now
connect the Master drive.
3. There are four/twelve corresponding IDE ribbon cables and power
connectors for each of the attached Target drives. Before connecting the
Target drives, make sure that the jumpers are set to either MASTER or
CABLE SELECT. You may now connect the Target drive(s).
4. Note that the drives are not powered until you actually start a copy
operation.
5. Note: The supplied cables are NOT standard IDE cables like the ones
found in a PC. Do not attempt to use these cables in a PC nor to use PC
cables with the KanguruClone HD.
6. You are now ready to begin using your KanguruClone HD. To begin, turn
on the unit with the power switch located on the back panel, select the
desired copy function, and press select.