JLCooper Eclipse Ethernet 2.6 for OSX - Manual (Page 16)

Assigning an IP Address to the Eclipse SX Midnight
To assign the IP Address on a standalone Eclipse SX Midnight, press the Page 4 and
Page 8 buttons at the same time. The display will show:
Press Page 7 to set the IP Address and Port number. The display will show:
Use the knobs below each number to the unique address you created earlier. 23 is a
good choice for the port. Press Page 8 when you are done.
To set the IP mask, press Page 4 + Page 8 once again to access the configuration
page. The right display will show:
Press Page 6 to set the IP subnet mask of the Eclipse SX Midnight. The displays will
show:
Use the knobs below each number to set the mask value you obtained from System
Preferences. Press Page 8 when you are done. In order for the new settings to take
effect, you must turn the Spectrum off and back on again.
Eclipse Ethernet Software
13